Top To Rear Vent Modification - Lopi Greenfield GSR2 Manual

Installation
Installation Warnings
! Failure to follow all of the requirements may result in property damage, bodily injury, or even
death.
! This heater must be installed by a qualified installer who has gone through a training program
for the installation of direct vent gas appliances.
! This appliance must be installed in accordance with all local codes, if any; if not, in U.S.A.
follow ANSI Z223.1 and NFPA 54(88), in Canada follow CSA B149.1. In Australia follow AS/NZS
5601.1.
! A manufactured home (USA only) or mobile home OEM installation must conform with the
Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280, or, when such
a standard is not applicable, the Standard for Manufactured Home Installations, ANSI/NCSBCS
A225.1, or Standard for Gas Equipped Recreational Vehicles and Mobile Housing, CSA Z240.4.
! This stove is designed to operate on natural gas or propane (LP).
! All exhaust gases must be vented outside the structure of the living-area. Combustion air is
drawn from outside the living-area structure.
! Notify your insurance company before hooking up this stove.
! The requirements listed below are divided into sections. All requirements must be met
simultaneously. The order of installation is not rigid – the qualified installer should follow the
procedure best suited for the installation.
SAFETY WARNINGS:
•
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.
•
DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR THIS APPLIANCE.
•
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN
OPERATION.
•
DO NOT MODIFY THIS APPLIANCE.
•
THIS INSTALLATION MUST CONFORM WITH THE FOLLOWING:
−
Manufacturer's Installation instructions
−
Local Gas Fitting Regulations
−
Municipal Building Codes,
−
Refer to AS/NZS 5601.1 for Gas Installations.
−
S.A.A. Wiring Code
−
Local Electrical Regulations
−
Any other statutory regulations
•
NOT SUITABLE FOR MARINE USE.
•
NOT INTENDED FOR FIREPLACE INSERT.
•
APPLIANCES INCORPORATING A LIVE FUEL EFFECT, AND DESIGNED TO
OPERATE WITH LUMINOUS FLAMES, MAY EXHIBIT SLIGHT CARBON
DEPOSITION.

Top to Rear Vent Modification

NOTE: If converting to rear vent, you will need the Minimum Vent Kit "D" (sku
96200317) from Travis Industries. This kit includes the necessary rear vent parts and
installation instructions. Make sure to review the vent configurations for rear vent
before proceeding.
© Travis Industries
(for qualified installers only)
2/23/18 - 1479 Greenfield GSR2-Aust
7