Lopi Greenfield GSR2 Manual page 56

Optional Equipment
56
7 Install the LP pilot orifice following the directions below.
(a) Use a 7/16" open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then replace
the pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
8 Replace the burner, making sure it is correctly seated. Before replacing the ember trays, make sure
the steel ember stands are all the way to the back.
© Travis Industries
(for qualified installers only)
2/23/18 - 1479 Greenfield GSR2-Aust