Accent Light Replacement - Lopi Greenfield GSR2 Manual

Maintenance
46

Accent Light Replacement

An accent light is included in your stove to provide additional lighting. To replace the bulb, follow the
directions below:
•
Disconnect stove from power. Shut off gas to the stove. Make sure the stove is cool before
proceeding (15 minutes).
•
Remove the stove top and place it aside (see page 27).
•
Remove the four screws securing the accent light cover. Place the cover aside.
•
Remove the two screws securing the accent light assembly. Place the assembly upside down on the
firebox top, making sure the wiring is not damaged or dislodged. When replacing, make sure the
glass is aligned below the assembly.
•
Loosen the two set screws nearest the bulb to disengage the bulb from the holder. Remove the bulb
from the holder. Replace the bulb, making sure not to touch the bulb with your fingers (grasp the bulb
with the bulb packaging or a paper towel). Tighten the screws until the bulb is secure (do not over-
tighten, this may damage the electrical contacts on the bulb). When the bulb is inserted into the
socket the two posts will be exposed approximately ¼" (6mm) – this is normal.
© Travis Industries
(for qualified service personnel only)
2/23/18 - 1479 Greenfield GSR2-Aust