Table of Contents
Advertisement
To Enable Service
Switch
NOTE
Disconnecting
Cables
Mounting the
Device
To mount the unit
This service switch is used to select safe boot for the Android processor.
Service switch:
During power up, press and hold the service switch to access the Android
Processor boot loader. Or press service switch to start the Android Sysmode
application.
Figure 6
EDL switch
EDL (emergency download) switch:
This switch is used to access the Android Processor Emergency Download mode.
These switches should be used only by the authorised service centers.
To disconnect cables, use the same steps described above in reverse. If
exchanging cables, use Verifone-approved cables. See
Documentation
for cable part numbers and ordering information.
Use the following procedure to mount the UX700 ML to a stand base.
•
Insert the cable from below the stand base as shown in
•
Pull the cable up and insert it into the hole of the stand base as shown in
Figure
7-2.
•
Insert the cable into the UX700 ML port as shown in
Mounting the Device
Accessories and
Figure
7-1.
Figure
7-3.
UX700 ML I
G
NSTALLATION
UIDE
S
ETUP
14
Advertisement
Table of Contents
