Magnetic Stripe Cleaning; Decommissioning/Removal From Service - VeriFone P630 Installation Manual

Magnetic Stripe
Cleaning
NOTE
Decommissioning/
Removal from
Service
NOTE
The Magnetic Stripe Reader (MSR) must be cleaned regularly (daily to once a
week, depending on usage), as dirt accumulation can lead to MSR reading
problems. MSR can be cleaned using commercially available card reader
cleaning cards or using recommended Verifone cleaning card (PN 02746-02).
If using a commercially available cleaning card use ONLY an approved MSR
cleaning card made specifically for POS MSR Card reader devices or Petroleum
MSR card readers.
The decommissioning procedure applies to P630 series PCI PTS version 6.x POI-
approved devices.
Failure to use this decommission procedure causes non-compliance to the PCI
PTS POI Modular Security Requirements version 6.0 approval of the device.
To securely decommission the device:
1
Prepare your tool — a #8 Phillips head screwdriver is necessary.
2
Ensure that the device is disconnected from power and any other cables.
3
Turn the device face down, exposing the rear of the device.
4
Using the Phillips head screwdriver, remove each of the eight screws. Four of
the screws are covered by the rear cable cover. You must remove the cable
cover to access these screws.
One screw is covered by a tamper-evident security label. Push the
screwdriver through this label to access the screw.
5
Once all the identified screws have been removed, carefully separate the top
housing plastics from the bottom 1mm, then pinch the top and bottom housing
back together ensuring a proper fit.
6
Reinsert all of the screws previously removed. Tighten each screw completely.
7
Insert the power cable and power up the device.
8
Turn the device face up showing the display and keypad. Verify that the unit is
in an "Active Tamper." You should see the *TAMPER* message displayed on
the screen.
M C
AINTENANCE AND LEANING
Additional Safety Information
P630 I G
NSTALLATION UIDE
33