Service; Routine Maintenance - Cartoni LIFTO 25 User Manual

safety button (11) and slip the camera plate (1) till completely disengage the
camera plate from the motorized column.
Remove the quick release camera plate (1) from the PTZ camera loosing the
1/4" (or 3/8") screw. Insert again the camera plate on the LIFTO 25, paying
attentiont to properly align the arrow, and tight the knob (10).
Disconnect the motor cable from the motorized elevation unit (7), and in-
sert the connector inside the safety ring (8), in order to protect the connec-
tor itself during trasportation and storage. Disconnect the motor cable, the
input device (25) and the power supply cable from the power supply unit
(19) and carefully put away all the wirings and the electronic devices in the
provided cable bag.
If previously extended, retract the multi-level spreader (3) to its shrinked
position, release the spreader knob (4) and fold the tripod to its folded po-
sition. Then, tight again the spreader knob (4).
Release the three leg clamping levers (2), lower the tripod pulling down the
flat upper base (6), then lock in place the three extendable legs (13) with
the three leg clamping levers (2).
24
9.
s
ervIce
The LIFTO 25 has been designed and built in a way to reduce as much as
possible any maintenance, and to ensure to be problem-free over time.
After any maintenance operation, the LIFTO 25 must be tested to ensure
that it is working properly.
9.1 r
outIne MaIntenance
The LIFTO 25 components should be carefully periodically inspected and
any damaged part immediately replaced to prevent failures that might com-
promise the safety of the LIFTO 25.