Mounting The Ptz Camera - Cartoni LIFTO 25 User Manual

Table of Contents

6.2 M

Mount the quick release camera plate (1) on the PTZ camera tightening the

appropriate screw (1/4" and 3/8" screws provided). Please pay attentiont to

properly align the arrow pointing toward the camera front.

If the PTZ camera does not have the mounting holes aligned with the opti-

cal axis, please use the accessory APTZ003 (not included).

Slide in the camera plate (1) into the plate support (9) up to centering the

PTZ camera on the LIFTO 25, then tighten the knob (10) to avoid undesired

camera movement.

Secure the PTZ camera connecting the camera safety leash, if any, to pre-

vent accidental fall-off.

Finally, wrap all the cables (motor cable, PTZ power cord, PTZ control cable,

etc.) using the provided self-winding sock.

Secure the wrapped up cables to the safety ring (8), using the provided

strain-relief strap, to prevent cables and connectors accidental damage.

The LIFTO 25 has been designed to support up to three PTZ cameras at the

same time, using the optional accessory PTZ T-Bar (APTZ001, not includ-

ed). For further information about the use of the PTZ T-Bar please refer to

the section 6.4 "Optional accessories".

opened LIFTO 25 base triangle (PTZ T-Bar, Teleprompt-

ers, ecc.) could cause the LIFTO 25 to tip over; use addi-

tional precaution to avoid accidents.

ountIng the

Items whose center of gravity (CG) is too close to the

ptz

caMera

Table of Contents