Cartoni LIFTO 25 User Manual page 17

Connect the motor cable to the power supply (19), using the first port avail-
able: if only one LIFTO 25 is being connected to the power supply (19),
choose the port "1" (22).
Connect the wired input device (25) to the power supply (19), via the RJ45
port labeled "A1" (24) or "A2" (23).
An extension cord, 2 m long, for the motor cable is provided in the kit, if
needed. The input device cable can be extended as well, using the provided
RJ45 coupler and a standard Ethernet cable (not included). Extensions ex-
ceeding 50 mt (164 Ft) are not advisable.
Finally, connect the power supply (19) to a AC plug via the AC port (18),
using the provided cable.
!
The power supply can handle up to four LIFTO 25 at
the same time. Please be advised that all the motorized
elevation units (7) connected to the same power supply
(19), will move simultaneously and not independently
one from the each others.
In case you need to connect more than one LIFTO 25 to the same power
supply unit (19), please proceed following the increase numbering of the
motorized elevation unit output ports.
To set the tripod height release the spreader knob (4) and then loose the
three leg clamp lever (2). Lift the tripod pulling up the tripod base (6) till
the desired height, then lock in place the three extendable legs (13) with
the three leg clamp levers (2). Adjust the opening angle of the legs (13) and
tighten the spreader knob (4). Finally, if needed, adjust the extension of the
spreader acting on the adjusting botton (5).
Set the horizontal postion of the tripod base (6) trimming the length of each
leg conveniently, loosing and then tightening the leg clamp lever (2). Check
the bubble level embedded (12).
17