Lightweight Dolly - Cartoni LIFTO 25 User Manual

!
opened LIFTO 25 base triangle (PTZ T-Bar, Teleprompt-
ers, ecc.) could cause the LIFTO 25 to tip over; use addi-
tional precaution to avoid accidents.
6.4.2 l
Assembling
The LIFTO 25 has been designed to be compatible with the CARTONI
Lightweight Dolly (D833), to in order to conveniently move the LIFTO 25
around the studio or set. To mount the LIFTO 25 on the dolly proceed as
follows.
20
Firstly, remove the three orientable feet (15) disengaging the rubber band
(14) for each foot. Then, remove each foot (15) tipping it around its spheri-
cal seat until snapping out the foot itself.
Completely open the dolly and place it on an even surface, engaging the
brake of each wheel so that the dolly cannot move during the LIFTO 25
installation.
Release the spreader knob (4).
Place the spherical seat of one leg (13) on the corresponding sphere of the
dolly and snap-in.
Extend as much as needed the spreader arm of the leg pushing the adjust-
ing button (5) and extend the spreader arm of a second leg (13), also.
Couple the second leg (13) seat on the corresponding sphere of the dolly
and snap-in it, too.
Subsequently, extend by the necessary amount the spreader arm of the
third leg pushing the adjusting button (5), place the third leg (13) seat on
the corresponding sphere of the dolly and snap in the leg.
Items whose center of gravity (CG) is too close to the
IghtWeIght dolly
(d833)