D-Tap Cable For V-Mount Batteries; Bluetooth Remote Control - Cartoni LIFTO 25 User Manual

6.4.3 d-t
The LIFTO 25 can be operated using batteries as well. To this specific pur-
pose, a dedicated accessory has been conceived in order to use two 14V
batteries with the D-Tap cable for V-Mount batteries (APTZ0005).
!
ply unit at the same time.
Connect each battery to one D-Tap connector of the cable and then con-
nect the 2-pins Molex connector to one of the to DC ports (16) of the pow-
er supply unit (19). It is strictly forbidden to connect batteries and AC plug
to the power supply unit at the same time.
22
The power supply unit sports two DC ports and the hot swap between bat-
teries is possible in order to not interrupt the operation. Nevertheless, con-
nect two D-Tap cables at the same time only for the time strictly necessary.
6.4.4 b
The operation of the motorized elevation unit (7) of the LIFTO 25 can be
controlled via an optional Bluetooth remote control.
Insert the receiver in one of the two control device input ports "A1" or "A2"
(23 or 24, respectively) of the power supply unit (19).
Press both transmitter buttons simultaneously to pair the transmitter with
the receiver.
The Bluetooth remote control is now ready and you can move the LIFTO 25
using the two buttons analogously to what you can do the the UP (26) and
DOWN (27) button of the wired input device (22). No storable positions are
available in this case.
ap cable for
Never connect batteries and AC plug to the power sup-
luetooth reMote control
v-M
ount batterIes