Cartoni LIFTO 25 User Manual page 21

Afterwards, secure all the three legs (13) using the rubber restrain bands of
the dolly itself.
Set the desired tripod height acting on the clamping levers (2) and finally
tighten the spreader knob (4).
Disassembling
To remove the LIFTO 25 from the dolly proceed as follows.
First, engage the brake on each wheel and retract the motorized elevation
column (7) to its lowest position.
Remove any payload or accessory placed on the LIFTO 25.
Lower the tripod to its minimum height position, acting on the clamping
lever (2) of each leg (13). Disengage the restraining rubber band (14), for all
the three rubber feet (16).
Uncouple one leg (13) from the spherical joint on the dolly, the slightly tilt
aside the LIFTO 25, as shown in the following figure: the other two sphere
will automatically pop-out from the corresponding spherical seat.
Release the spreader knob (4) and completely fold the tripod, then tighten
21
the knob (4) again.
Finally, fold the dolly.