Use Of Optional Accessories; Ptz T-Bar - Cartoni LIFTO 25 User Manual

At the first switch on, push and hold the DOWN button (27) to reach and
set the lowest position.
During normal operation, adjust the height of the motorized elevation col-
umn (7) using the wired input device (25), acting on the buttons UP (26) or
DOWN (27).
Three differerent positions can be stored. To store the current position
press the "s" button (31) and then the desired memory button: "1" (28),"2"
(29) or "3" (30). To recall a position press and hold the corresponding but-
ton: "1" (28),"2" (29) or "3" (30). Each time a new position is stored the pre-
vious one, if existing, is overwritten.
The PTZ T-Bar has been designed to use up to three (Depending on size/
or weight) at the same time. This smart and convenient device, is made by
a main frame member on which three camera interface can slide back and
forth to adjust the camera position.
To install the PTZ T-Bar couple the quick release camera plate with the
central sliding interface, then slide in the camera plate (1) into the plate
support (9) up to centering the PTZ T-Bar on the LIFTO 25, then tighten
the knob (10).
6.3 o
peratIng the
6.4 u
se of optIonal accessorIes
6.4.1 ptz t-b
LIFTO 25
(aptz001)
ar
19