General Specifications - VADDIO ROBOSHOT12 Installation And User Manual

RoboSHOT HD Cameras
G S
ENERAL PECIFICATIONS
Function
Part Numbers
Image Device
Video Resolution/Frequencies
Vaddio Special Features
Video Aspect Ratio
Effective Pixels
RoboSHOT 12
Lens and Horizontal FOV
RoboSHOT 30
Lens and Horizontal FOV
Minimum illumination RoboSHOT 12
Minimum illumination RoboSHOT 30
Minimum working distance RoboSHOT 12
Minimum working distance RoboSHOT 30
S/N ratio
Sync system
White balance
Gain
Back-light compensation
Focusing system
Noise Reduction
Aperture/Detail
Control Interface(s)
Pan & Tilt Angle/Speed
Rear Panel Connectors
Rear Panel Controls
Power Supply
Compatible Joystick and Video Control
Consoles
Operating/Storage Temperature/Humidity
Mass
Dimensions
Quick-Connect DVI/HDMI SR
Quick-Connect System
Connectors
Cat-5 Cable Distance
Power Supply
Dimensions / Weight
Accessory Options
RoboSHOT HD Cameras - Document Number 342-0795 Rev A
Description
RoboSHOT 12 QDVI System, 999-9906-000 (North America), 999-9906-001 (Int'l)
RoboSHOT 30 QDVI System, 999-9916-000 (North America), 999-9916-001 (Int'l)
1/2.8-Type Exmor CMOS Sensor
1080p60/59.94/50/30/25, 1080i/60/59.94i/50, 720p/60/59.94/50/30/25
 Tri-Synchronous Motion: Concurrent PTZ motor movement and simultaneous PTZ arrival at a stored
preset
 Advanced ISP: Vivid and accurate color reproduction with extremely fast, razor sharp automatic focus
and iris routines
16:9 Aspect Ratio for all resolutions
2.14 Million Effective pixels
2.38 Million Total Pixels
12X Optical Zoom, Super Wide Mode: 73.0° (wide) to 6.6° (tele),f=3.91mm to 47.0mm, F1.8 to F3.4
10X Optical Zoom, Normal Mode: 67.3° (wide) to 7.6° (tele), f=3.8mm to 38.0mm, F1.8 to F3.4
NOTE: Default is Normal Mode
30X Optical Zoom
65° (wide end) to 2.3° (tele end), F1.6 to F4.7
1.0 lx (F1.8, 50IRE), recommended illumination >100 lux and <100,000 lux
1.4 lx (F1.6, 50IRE), recommended illumination >100 lux and <100,000 lux
10mm (wide), 800mm (tele)
10mm (wide), 1.2m (tele)
More than 50 dB
Internal
Auto, ATW, Indoor, Outdoor, One-push, Manual (accessible through external control)
Auto / Manual (0 to 28 steps - accessible through external control)
On/Off (IR Remote)
Auto Focus / Manual Focus Mode / One Push Trigger Mode / Infinity Mode / Near Limit Mode
On/Off, 6 Steps, Off through 5 (accessible through external control)
16 Steps (accessible through external control)
 RS-232 API: Modified VISCA Emulation (TTL signal level), Baud rate: 9600 bps and 38,400 bps, 1-Stop
bit. Default to 9.6 Kb/s for Cat-5e Distance
 Telnet Serial Command API
 Internal Web page for Network Set-up, firmware updates and network management
 Vaddio IR Remote Commander
Pan/Tilt Angles: ±160°, Tilt: +90°, -30°,
Pan/Tilt Speeds: Both Axes 0.35°/sec to 120°/sec
 Network: RJ-45 with Green & Yellow LED to show connection and usage
 RS-232: RJ-45, Carries bidirectional control to and from the camera
 EZ Power Video: RJ-45 Shielded, carries power and differential video signals for the Quick-Connect
Cat-5 systems
 16-Position Rotary Switch for Resolution selection
 8-Position Dip Switch for IR Frequency, Image Flip, wide mode and Reset to Default Settings
Powered by Quick-Connect interfaces
ProductionVIEW Precision Camera Controller
ProductionVIEW HD
ProductionVIEW HD MV with Integrated Multi-viewer,
ProductionVIEW HD-SDI MV with Integrated Multi-viewer
AV Bridge MATRIX PRO
0°C (32°F) to 40°C (104°F), 20% to 80%
4.85 lbs.(2.199923 kg - Roughly 900 peanut M&Ms)
Small (3 dimensions not counting space/time)
6.942" (176.3mm) H x 7.056" (179.2 mm) W x 6.757" (171.6mm) D,
Quick-Connect DVI/HDMI (two Cat-5e) for distances up to 100' (30.84m)
HDMI or DVI-D and Analog Component YPbPr output with IR forwarding

Power Connector: 5.5mm OD, 2.5mm ID coaxial connector

RJ-45: Four (4) Control IN, Control OUT, Daisy Chain OUT, EZCamera Power Video Port

Video Output: DE-15 connector for HD Analog Component (Y,PB,PR) video only (No SD Support)

IR Output: Transmits modulated or non-modulated IR signals received from the HD-19 IR receiver

Video Outputs: DVI-D (Female - Single Link) or HDMI with adapter cable (using the Recessed Color
Space Conversion Switch) , DE-15F (High Density D-Sub 15-Pin F) for HD YPbPr
Up to 100' (30.5m)
24 VDC, 2.0 Amp Switching Power Supply
1.6" (40.64mm ) H x 8" (203.2mm) W x 6.751" (171.45mm) D, ½-Rack Size / 1.21 lbs. (0.548846804 kg)
1-RU Rack Mount Panel for two (2) units (side by side): P/N: 998-6000-003
1m (3.3') DVI-D Male to HDMI Male P/N: 440-5643-001
3m (10') DVI-D Male to HDMI Male P/N: 440-5643-003
Page 26 of 44