Controlling The Camera; Ir Remote Commander; Telnet Control - VADDIO ROBOSHOT12 Installation And User Manual

RoboSHOT HD Cameras
C C
ONTROLLING THE AMERA

IR Remote Commander

The following functions are accessible with the Vaddio IR remote:

Camera Power On/Off (Toggle on/off same button)

Back Light Compensation (Toggle on/off same button)

Data Screen: Toggle on/off the OSD for the RoboSHOT's IP/MAC Address

Camera Select (the remote can operate 3 cameras (with 3-IR Freq.)

Pan/Tilt and Home controls with Reverse and Std. Pan direction

Pan/Tilt Reset

Auto Focus (Toggle on/off same button)

Zoom In/Out controls Wide & Telephoto
 Fast speed controls (W & T)
 Slow speed controls (W & T)

Manual Focus On/Off control (Toggle on/off same button)
 Near (-) adjustment
 Far (+) adjustment

Six (6) pan/tilt/zoom positioning presets (1 through 6)

Preset Set (store)

Preset Reset (clear)

Red LED that indicates IR Transmission and battery level
The IR Remote operational characteristics are as follows:

Preset Activation: IR Remote is limited to executing Presets 1 through 6

Tri-Sync Speed on Preset: If a global Tri-Sync speed is stored in the preset by the user/admin, then that
speed is used. If no Tri-Sync speed is assigned, then a default (medium) speed will be used.

Preset Store: IR Remote is limited to positional (PTZ) type presets. To set a preset, position the camera,
hold down the Preset Button and touch the one of the preset numbered buttons 1 through 6.

Telnet Control

*
The following Telnet commands are available through the Ethernet Port.

Camera Home

Camera Pan (left, right and speed - real-time operation)

Camera Tilt (up, down and speed - real-time operation)

Camera Zoom (zoom in/out/stop and speed - real-time operation)

Camera Store Preset (Gets or Sets 12 presets with global relative PTZ [Tri-Sync] speed control to destination)

Camera Image (Gets or sets current image control values, sets in 1 of 3 CCU presets)
(AWB or manual w/Red and Blue gain, BLC on/off, Auto Iris or manual with Iris value and Gain, Detail and Chroma)

Camera Sleep (Gets or sets standby power mode - camera has to us less power in this mode)

Exit (ends Telnet session)

Help (displays CLISH syntax)

History (command history)

Network Ping (send ICMP ECHO_REQUEST to network hosts)

Network Settings (Gets MAC address, IP address, Subnet Mask, Gateway and NTP server address)

Network (Gets the current network settings or pings an IP address)

Streaming Mode - USB or IP needs to be changed to USB and IP (get and set streaming modes, on/off)

Streaming Quality (gets/sets high/standard/low for IP)

Streaming Resolution (gets/sets streaming resolution)

Streaming (gets/sets current streaming settings)

System Factory Reset

System Reboot

Version (system version information)
*
Please see the full Telnet command list at the end of this manual
RoboSHOT HD Cameras - Document Number 342-0795 Rev A
Vaddio
IR Remote
Commander
Page 14 of 44