Spreader Setup - PROAIM Kite-22 Assembly Instructions Manual

Jib Stand Setup

Now take out the Tripod Stand from its case,
and stretch its legs on floor as per the
requirement. Then tighten the knob to
secure it.

Match holes of the bottom leg section with
the upper leg section to secure tripod stand
with Steel locking Pins and tighten the knob.
NOTE: We have provided double locking
precautions on Jib Stand. Pin is first and primary
locking knob is secondary locking so first lock
the Pin to avoid slipping of stand.

Spreader Setup

NOTE: For setting up your desired package with spreader or with floor dolly follow the below steps:

Take out Spreader and spread it on floor and
open the legs (as per your requirement)
spreader with the help of provided knob.

Put tripod stand on spreader & then lock it in
place with the rubber grips. (Note: Tighten
the ratchet knob of stand to secure it with
rubber grips.
of
Knob
Pin
5