PROAIM Kite-22 Assembly Instructions Manual page 7


Remove ratchet knobs of the stand, Insert
the tripod legs into the foots on the dolly.

Then tighten the provided knob of tripod
holder.
Hub Section Setup
NOTE: The Hub Assembly has several mounting holes. You can mount LCD Monitor or Joystick box to
this assembly if you want.

Install the Hub Assembly by sliding from the
bottom side into the stand's Mount opening.

Insert the bolts with washers and tighten
properly with the help of Wrench.
NOTE: This is the Pan Friction Knob. Never pan the Jib with this knob tightened. If this knob turns while
panning, it is too tight. Only tighten while parking the jib!

Insert the provided washer & knob to secure
the jib properly.
7