PROAIM Kite-22 Assembly Instructions Manual page 8

Jib Sections Setup

Insert rear tube section (section 1) into the
hub assembly, slide section 2 into section 1
and align holes of the Section 1 and section 2
with the central hole of hub assembly.

Already attached 1st or 2nd jib sections,
insert it onto the hub then insert the long
bolt and nut to Secure the sections properly.
NOTE: We have provided double locking precautions on Jib, Knob is first and primary and pin is
secondary locking so first lock the knob to avoid slipping of sections.

After alignment of holes (Jib arms) insert
hank lock pin & tighten it from another side
with hank threaded cap. For double security
insert the locking pin from the top of jib arm.

Repeat this process for rest of the sections.
Attach them towards the other Section 6 with
5 , 5 with 4, 4 with 3, 3 with 2 & 2 with 1.
Head Section Setup

Remove the bolt from head section then
attach with the jib.
3
2
1
8
2
1