L1-03: Motor Thermistor Oh Alarm Select; L1-04: Motor Thermistor Oh Fault Select - YASKAWA T103 Installation & Primary Operation

12 UL Standards
Figure 12.3 Protection Operation Time for a General-purpose Motor at Rated Output Frequency
■

L1-03: Motor Thermistor oH Alarm Select

No.
Name
(Hex.)
L1-03 Motor Thermistor oH Alarm
Select
(0482)
0 : Ramp to Stop
The drive ramps the motor to stop in the deceleration time. Fault relay output terminal MA-MC turns ON, and MB-
MC turns OFF.
1 : Coast to Stop
The output turns off and the motor coasts to stop. Fault relay output terminal MA-MC turns ON, and MB-MC turns
OFF.
2 : Fast Stop (Use C1-09)
The drive stops the motor in the deceleration time set in C1-09 [Fast Stop Time]. Fault relay output terminal MA-MC
turns ON, and MB-MC turns OFF.
3 : Alarm Only
The keypad shows oH3 and the drive continues operation. The output terminal set for Alarm [H2-01 to H2-03 = 10]
activates.
■

L1-04: Motor Thermistor oH Fault Select

No.
Name
(Hex.)
L1-04 Motor Thermistor oH Fault
Select
(0483)
0 : Ramp to Stop
The drive ramps the motor to stop in the deceleration time. Fault relay output terminal MA-MC turns ON, and MB-
MC turns OFF.
1 : Coast to Stop
The output turns OFF and the motor coasts to stop. Fault relay output terminal MA-MC turns ON, and MB-MC turns
OFF.
2 : Fast Stop (Use C1-09)
The drive stops the motor in the deceleration time set in C1-09 [Fast Stop Time]. Fault relay output terminal MA-MC
turns ON, and MB-MC turns OFF.
66
V/f CL-V/f OLV CLV AOLV
Sets drive operation when the PTC input signal entered into the drive is at the oH3 [Motor Overheat
Alarm] detection level.
V/f CL-V/f OLV CLV AOLV
Sets the drive operation when the PTC input signal to the drive is at the oH4 [Motor Overheat Fault
(PTC Input)] detection level.
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
YASKAWA TOEPC71061782C GA800 Drive Installation & Primary Operation
Default
(Range)
3
(0 - 3)
Default
(Range)
1
(0 - 2)