3.
Push on the four tabs found on each side of the front cover, then pull the front cover forward to remove it from
the drive.
A - Pull forward to remove the front cover.
4.
Remove the front cover from the drive.
Reattach the Front Cover
Wire the drive and other peripheral devices then reattach the front cover.
Note:
Wire the grounding terminals first, main circuit terminals next, and control circuit terminals last.
1.
Move the front cover to connect the hooks at the top of the front cover to the drive.
A - Hooks
2.
Move the front cover until it clicks into position while pushing on the hooks on the left and right sides of the
front cover.
Note:
Make sure that you do not pinch wires or signal lines between the front cover and the drive before you reattach the cover.
YASKAWA TOEPC71061782C GA800 Drive Installation & Primary Operation
Figure 6.9 Pull Forward to Remove the Front Cover
Figure 6.10 Remove the Front Cover
Figure 6.11 Reattach the Front Cover
B - Unhook the tabs found on the sides of the front
cover.
6 Mechanical Installation
19