YASKAWA T103 Installation & Primary Operation page 20

6 Mechanical Installation
3.
Reattach the keypad to the original position.
Remove the Terminal Cover
1.
Loosen the screws on the terminal cover, then pull down on the cover.
CAUTION
the terminal cover can fall and cause moderate injury.
2.
Pull the terminal cover away from the drive.
Reattach the Terminal Cover
Wire the drive and other peripheral devices then reattach the terminal cover.
Note:
• Wire the grounding terminals first, main circuit terminals next, and control circuit terminals last.
• Make sure that you do not pinch wires or signal lines between the wiring cover and the drive before you reattach the cover.
• Tighten the screws to a tightening torque of 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in).
20
Figure 6.12 Reattach the Front Cover
Crush Hazard. Loosen the cover screws. Do not fully remove them. If you fully remove the cover screws,
Figure 6.13 Loosen the Terminal Cover Mounting Screws
Figure 6.14 Remove the Terminal Cover
YASKAWA TOEPC71061782C GA800 Drive Installation & Primary Operation