Systems; Sea Water - Pro-Line Boats 17 Sport Owner's Manual

11
Breaker Switches
The wiring on your Pro Line is protected by circuit breaker or fuse. Breakers are located
beside the switches or on the main breaker panel on the transom panel. If a device stops
working first suspect the circuit breaker is tripped (or fuse blown).
A tripped breaker will protrude from its set position, indicating that the circuit has been
overloaded. Turn off the device(s) on the circuit then reset the breaker by pushing in
once. If the breaker does not reset or if it resets and then pops out again after the device is
turned back on, then a short circuit exists or your device may be damaged, overloaded or
faulty. Correct the problem and then reset the breaker. If the breaker continues to pop
and you are certain the device, switch and wiring are in good repair; either the breaker is
too small for the load or is faulty. Reduce the load or replace the breaker.

Systems

Sea Water System
The bait-well switch controls a pump mounted on a sea-cock in the bilge. An overflow
tube is provided that is inserted into the drain to allow circulation to keep bait alive. Raw
water is taken in by the thru-hull fitting with a sea-cock. Sea-cocks on all below water
line fittings should be closed when not in use.
Bilge Pump Bait-well Pump
Float switch Sea-cock shut off Valve