Check Point QUANTUM SPARK 1595R Getting Started Manual page 38

If the gateway connects to the internet through DHCP, the gateway will fetch the Zero Touch settings without
any additional action. If no DHCP service is available, you must run the First Time Configuration Wizard,
configure the Internet Connection
To connect to the Zero Touch server:
1. In the Welcome
2. In the window that opens, click
3. The Internet connection
4. The Fetching settings from the cloud
provider status. This process may take several minutes.
5. If you fail to connect, an error message appears. Possible errors include:
Internet connection is not configured correctly.
n
n Internet connection is through a proxy server.
Zero Touch is already running.
n
Zero Touch service already completed.
n
The First Time Configuration Wizard already completed.
n
Zero Touch service is disabled.
n
Where applicable, click
6. After you connect to the server, the settings are automatically downloaded and installed. The status is
shown in the Fetching settings from the cloud
installation is complete.
7. Click Finish.
Note - If a collision is detected between an internal network (LAN) and an IP returned
using DHCP (WAN), the conflicting LAN address is changed automatically. If a colliding
LAN IP address is changed, a message appears in the system logs.
When you reconnect to the WebUI or click Refresh, the browser opens to show the status of the installation
process.
After the gateway downloads and successfully applies the settings, it does not connect to the Zero Touch
server again.
settings, and then fetch the settings from the Zero Touch server.
page, click Fetch Settings from the
OK to confirm that you want to proceed.
page opens. Configure your Internet connection and click Connect.
window opens and shows the
Retry now to connect again.
cloud.
Connecting to the service
window. It may take several minutes until the
Quantum Spark 1595R Getting Started Guide | 38
Welcome