Table of Contents
Advertisement
7.1. Pre-installation preparation
For
installations
combustible materials, complete the enclosure and install
the #770ZCK zero clearance kit in accordance with the
instructions supplied with the kit.
7.1.1 Closing Large Fireplace Openings
This appliance is suitable for solid fuel fireplace openings
within the sizes shown in figure 1a. Larger fireplace
openings may be reduced or the outer surround plate
extended using non-combustible materials.
7.1.2
Remove Window and Logs (see fig.3).
•
Detach the window unit by removing the two screws
situated at the bottom corners of the unit.
•
Lift the window unit up and forwards to unhook the
top. Put the window in a safe place.
•
Take the ceramic logs out of the firebox and store in a
safe place.
7.1.3
Check Ignition Electrode Spark.
The pilot burner and electrode unit is at the right end of the burner.
Push in the lighting knob and turn counter-clockwise through the
"IGN" position to "PILOT". A spark should flash across from the pilot
electrode to the pilot burner shield. See figure 4.
7.1.4
Check flame control motor.
•
Fit the four batteries into the battery box (Which is attached to the
switch wires).
•
Temporarily connect the black connector pad to the control unit –
See figure 5.
•
Operate the switch. This should cause the flame control knob to
rotate counter-clockwise. See figure 5.
•
Disconnect and remove after checking.
7.1.5
Remove the Vent Connection Unit.
Detach the vent connection unit from the top of the appliance case by
removing the screw at front. Slide the vent connection unit back and lift clear (see fig.6).
7.1.6
Fit the control knob extension firmly over the gas control knob. (See fig.7)
Fig. 5
7. INSTALLATION
in
enclosures
constructed
Fig. 6 Vent connector removal
with
Fig. 3 Window removal
Fig. 4 Pilot ignition system
10
(Shown with Standard Front Frame)
Fig. 7 Control knob extension
Hide quick links:
Advertisement
Table of Contents
