Table of Contents
Advertisement
11.6 To Grease the Gas Tap
11.6.1.
Remove the burner module as section 115.
11.6.2.
Remove the circlip holding the piezo generator to the tap.
11.6.3.
Remove the two screws from the head of the tap.
11.6.4.
Remove the spindle and spring from the tap.
11.6.5.
Note the position of the slot in the plug. Mark this position on the tap body.
11.6.6.
Rotate the plug and pull it out of the tap.
11.6.7.
Clean and grease the plug lightly with suitable grease. Do not apply excessive
grease. Particularly, make sure that the gas ports are not restricted by grease.
11.6.8.
Push the plug back into the tap body. Line up the slot in the plug with the
mark previously made on the tap body.
11.6.9.
Reassemble in the reverse order making sure that the components are correctly
engaged. Check the operation of the tap and piezo. Make sure that the control knob with
spindle is correctly turned to agree with the gas tap position before refitting the split pin.
12 REPLACEMENT PARTS – SHORT LIST
KEY
A
Gas Tap & Spark Generator
Spark Generator
B
C
Upper injector Bray Cat. 16 Size 120
D
Lower injector Bray Cat. 28 Size 250B
Pilot Unit
E
F
Control Knob
G
Radiant
H
Dress Guard
Dust cage
J
INSTALLER GUIDE
DESCRIPTION
Page 22
No. OFF
PART No.
1
0579089
1
0536939
1
0544619
1
0545199
1
0579099
1
0544659
3
0544649
1
0579109
1
0567619
Advertisement
Table of Contents
