Pre-Installation Preparation; Unpacking; Fireplace Flue Pull - Valor Regency OXYSAFE 2 Installer's Manual

4.14 If the fire is to be fitted against a wall with combustible cladding, the cladding must
be removed from the area shown in figure 3.
4.15 An extractor fan may only be used in the
same room as this appliance, or in any area
from which ventilation for the appliance is
taken, if it does not affect the safe performance
of the appliance. Note the spillage test
requirements detailed further on in this manual.
If the fan is likely to affect the appliance, the
appliance must not be installed unless the fan is
permanently disconnected.
4.16 The space between the fireplace front face
and the back of the outer case must not be filled
in.
4.17 If the fireplace opening is greater than the acceptable dimensions given in this
guide, do not use the back of a fire surround or marble to reduce the opening. This
may cause cracking of the surround back or marble.
5 P R E - I N S T A L L A T I O N P R E P A R A T I O N

5.1 Unpacking

This appliance is supplied completely assembled except for:-
3 radiants which are in a cardboard pack inside the firebox.
•
The closure plate
•
Literature pack
•
An olive & olive nut for gas line connection
•
Remove all the items carefully to prevent damage. Some items may be contained in the
packaging fitments -Examine the packaging carefully before discarding. Check that all the
items are present and undamaged.

5.2 Fireplace Flue Pull

Close all doors and windows in the room in which the appliance is to be installed. After
confirming with a match that smoke is drawn into the flue, light a 13 gram smoke pellet
and check that there is a definite flow through the flue. Verify outside that the smoke
exits from one terminal only and that the termination is suitable. Observe, where
possible, upstairs rooms and loft spaces for signs of escaping smoke indicating a
INSTALLER'S GUIDE
Page 11
Figure 3. Area to be free of
combustible cladding