To Replace The Burner - Valor Ultimate Installer's Manual

5. Detach the injector pipe
6. Detach the electrode lead
from the base of the
electrode
7. Remove the control knob
by pulling forward.
8. Remove the thermocouple
by unscrewing the
thermocouple nut at the gas
valve.
9. Remove the hexagonal nut
securing the gas valve to the
mounting bracket.
10. Remove the gas valve
11. Refit in the reverse order.

17.6 To Replace the Burner

See figure 36.
1. Remove the burner unit - See
section 17.3.
2. Support the elbow injector and
unscrew the injector nut.
3. Remove the two screws from the
burner clamping plate (See figure 36)
4. Lift the right hand side of the
burner, slide it to the right and lift
clear
5. Refit in reverse order.
INSTALLER GUIDE
Figure 35. Gas valve (Viewed from
rear with burner turned over)
Figure 36. Removal of burner
Page 33