Recording A Measurement - Noraxon Ultium EMG Quick Start Manual

Ultium EMG Quick Start Guide

5 Recording a Measurement

Step 1
Within the Home screen, click on the myoMUSCLE module
icon.
Create a New Subject
Select New Configuration.
Step 2
Insert the devices to be used for the measurement into the
configuration by dragging a device in from the list of Available
devices.
Use the sensor list to select or deselect the number of sensors
to be used within the configuration. While the sensor is
selected, assign a name to the channel by selecting the
corresponding muscle on the 3D Muscle Map or entering the
name manually.
Continue to the next step by selecting Measure.
Step 3
After checking for normal signal display, you are ready to
record a measurement. Select Record at the top left of the
screen and begin your protocol.
After completing your record, select Stop and Save. Save the
record as the name of your configuration, or type in a new
name. After this, save your record or Discard & measure again.
(Rev B)
7