Noraxon Ultium EMG Quick Start Manual page 6

Ultium EMG Quick Start Guide
Step 4
Make sure the EMG or SmartLead Sensors are placed in the
Charger(s) and the Charger(s) are connected to the Ultium
Receiver, then click Detect Sensors in Chargers to load all
sensor serial numbers into the MR3 software.
Note: The first serial number in the list is associated with
the Sensor closest to the front of the Charger (i.e., toward
the Charger LEDs).
Step 5
After detection is complete, click Replace to replace all
existing sensor serial numbers associated with this device
or Add to append additional sensor serial numbers to an
already existing list.
Step 6
Click OK (in the bottom right corner of the dialog box) to
save the hardware settings.
4.1 Configuration using Ultium SmartLeads
If you are only using the sEMG SmartLeads, continue to Section 5: Recording a
Measurement.
Make sure the SmartLead is connected to the Ultium sensor before choosing Detect
Sensors in Charger. The Ultium sensor LED will flash purple when a SmartLead is
connected, and orange when the SmartLead is disconnected.
If the software does not recognize the SmartLead, the sensors may require a firmware
update. Follow the instructions for Device Software (firmware) updates.
The SmartLead will be listed with the SmartLead serial number, not the Ultium sensor
serial number.
Click OK (in the bottom right corner of the dialog box) to save the hardware settings.
(Rev B)
6