Installing The Hardware - Noraxon Ultium EMG Quick Start Manual

Ultium EMG Quick Start Guide

2 Installing the Hardware

Step 1
Insert the USB cable (#CBL2) into the USB connector on
the back of the Ultium Receiver (#880).
Insert the opposite end of the USB cable into an available
USB port on the computer.
Step 2
Insert one EMG SmartLead (#842) into each EMG sensor
(#810).
Step 3
Insert the EMG sensors into the Sensor Charger (#873).
Note: Sensor power button & LED must face the front of
the Charger, i.e., toward the charger LEDs.
Step 3
Connect the Receiver to the Sensor Charger (#873) using
the ports on either side of the Receiver.
Step 4
Insert the power supply (#PSU1) barrel connector into the
associated receptacle on the back of the Ultium Receiver
to charge sensors.
Note: Sensor LED will show solid orange while charging
and turn off when fully charged.
(Rev B)
3