Noraxon Ultium EMG Quick Start Manual page 2

Ultium EMG Quick Start Guide
On behalf of Noraxon...
Welcome and congratulations on acquiring your new Ultium EMG System!
This guide will provide you with step-by-step instructions on how to install your new hardware and software, adjust device
settings, and record your first data set.
Let us begin by walking through how to install your new hardware.
Note: This is not meant to be a complete user manual, but a guide to help you get started with your system. For more
detailed operating instructions for the Ultium EMG System, please refer to the Ultium EMG User Manual (P-8808).
1 System Unboxing
The Ultium EMG System is packed within a reinforced padded box for storage and protection during transport. Upon arrival,
carefully remove all contents and verify the following components are present.
Figure 1 – Ultium Receiver (part #880)
Figure 4 – Ultium EMG Smart Lead (part # 842)
Figure 7 – Sensor Charger to Receiver cable
(part #CBL34)
Additional items that may be included with your Ultium EMG System are:
•
Double-sided sensor tape (part #874E)
•
EMG electrodes (typically dual electrodes (part #271S)
•
Ultium EMG Hardware User Manual (part #P-8808)
(Rev B)
Figure 2 – EMG Sensor Docking Station (part #873)
Figure 5 – A to B USB Cable (part #CBL2)
Figure 3 - EMG Sensor (part #810)
Figure 6 - EMG Sensor Charger Power
Source (part #PSU1)
2