Configuring The Hardware - Noraxon Ultium EMG Quick Start Manual

Ultium EMG Quick Start Guide

4 Configuring the Hardware

Before the Ultium system can be used, the device software settings must be configured to recognize the different
components that make up the system. Follow the below instructions to update the receiver firmware, sensor firmware, and
populate sensors to prepare for a data collection.
Step 1
Open MR3, typically listed under Noraxon -> MR3
Click on the Hardware Setup button in the upper right-hand
corner.
Step 2
Select the Ultium icon, within the 'New Device' column, and
click on the Insert button.
Note: Make sure the Receiver is attached to the USB port of
the computer.
Step 3
The Ultium hardware setup window will appear as shown.
Within the "General" tab, select the desired settings for the
system, i.e., name, sample rate, cutoff filters.
Note: If available, firmware updates for the Receiver and
Sensors will be indicated here.
If using myoSYNC, click the Use Noraxon myoSYNC
checkbox.
Additional settings are available within the "Advanced" tab.
Note: If multiple Ultium systems are in use, separate RF
networks assignments are required for each Receiver.
(Rev B)
5