Yamaha MIO Service Manual page 229

_
• Use only the designated brake fluid.
Other brake fluids may cause the rubber
seals to deteriorate, causing leakage and
poor brake performance.
• Refill with the same type of brake fluid
that is already in the system. Mixing
brake fluids may result in a harmful
chemical reaction, leading to poor brake
performance.
• When refilling, be careful that water does
not enter the brake master cylinder reser-
voir. Water will significantly lower the
boiling point of the brake fluid and could
cause vapor lock.
CAUTION:
_
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean
up any spilt brake fluid immediately.
NOTE:
_
If DOT 4 brake fluid is not available, DOT 3
brake fluid can be used.
6. Bleed:
• brake system
7. Check:
a • brake fluid level
8. Check:
• brake lever operation
6 - 29
FRONT BRAKE
WARNING
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" in chapter 3.
Below the minimum level mark a → Add
the recommended brake fluid to the proper
level.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" in chapter 3.
Soft or spongy feeling → Bleed the brake
system.
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" in chapter 3.
CHAS