Yamaha MIO Service Manual page 228

FRONT BRAKE
3. Install:
• brake master cylinder 1
• brake master cylinder bracket
• brake master cylinder bracket upper bolt
• brake master cylinder bracket lower bolt
(temporarily)
NOTE:
_
• Install the brake master cylinder bracket with
the "UP" mark facing up.
• Install the brake master cylinder within 33.5°
from the horizontal line shown in illustration.
• Install the brake master cylinder bracket as
shown.
• First, tighten the upper bolt, then the lower
bolt.
a 175 mm (6.89 in)
4. Install:
• brake lever 1
• copper washers 2
• brake hose 3
• union bolt 4
WARNING
_
Proper brake hose routing is essential to
insure safe motorcycle operation. Refer to
"CABLE ROUTING" in chapter 2.
NOTE:
_
• When install the brake hose onto the brake
master cylinder, make sure the brake pipe a
touches the projection b as shown.
• Turn the handlebar to the left and right to
make sure the brake hose does not touch
other parts (e.g., wire harness, cables,
leads). Correct if necessary.
5. Fill:
• brake master cylinder reservoir
(with the specified amount of the recom-
mended brake fluid)
Recommended brake fluid
DOT 4
6 - 28
CHAS
11 Nm (1.1 m · kg, 8.0 ft · lb)
New
26 Nm (2.6 m · kg, 19 ft · lb)