Yamaha MIO Service Manual page 221

FRONT BRAKE
2. Install:
• brake caliper 1
(temporarily)
• copper washers 2
• brake hose 3
• union bolt 4
WARNING
_
Proper brake hose routing is essential to
insure safe motorcycle operation. Refer to
"CABLE ROUTING" in chapter 2.
CAUTION:
_
When installing the brake hose onto the
brake caliper 1, make sure the brake pipe
a touches the projection b on the brake
caliper.
3. Remove:
• brake caliper
4. Install:
• brake pad springs
• brake pads
• brake pad holding bolt
• pin
New
• brake caliper
• brake caliper upper bolt
• brake caliper lower bolt
• brake hose holder
• brake hose holder bolt
Refer to
BRAKE PADS".
5. Fill:
• brake master cylinder reservoir
(with the specified amount of the recom-
mended brake fluid)
Recommended brake fluid
DOT 4
6 - 21
CHAS
New
26 Nm (2.6 m · kg, 19 ft · lb)
10 Nm (1.0 m · kg, 7.2 ft · lb)
43 Nm (4.3 m · kg, 31 ft · lb)
23 Nm (2.3 m · kg, 17 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
"REPLACING THE FRONT