Reset Saturation Indicator Alarm; Replacing The Led Light Bulbs - V-ZUG AiroClearCabinet V6000 Operating Instructions Manual

Removing
▸ Pull the deflector plate completely out and remove the metal grease filters.
▸ Using the handle
guide rail.
Cleaning and regenerating
▸ Heat the activated charcoal filter unit
▸ Select top/bottom heat or hot air at 200 °C and regenerate on the wire shelf for 60
minutes.
▸ Allow to cool down.
After heat regeneration in the oven, allow the activated charcoal filter to cool down
before putting it back in the range hood. Risk of burns!
▸ Reassemble in the reverse order.
▸ Reset saturation indicator alarm (see page 17).
Dispose of the spent long-life-Plus activated charcoal filter at a suitable recycling
point.
4.4

Reset saturation indicator alarm

Reset the saturation indicator alarm for both the metal grease filter
charcoal filter after cleaning/replacing.
▸ With the appliance switched off, hold the
– If reset correctly, the
4.5

Replacing the LED light bulbs

For safety reasons, the LED light bulbs must be replaced by our Customer Services.
2
1
, remove the activated charcoal filter unit
and symbols are no longer displayed.
200°C
3
in the oven .
button depressed for 5 seconds.
4 Care and maintenance
1h
down and out of the
and the activated
17