Table of Contents
Advertisement
Trouble-shooting connection error
No connection can be established between the range hood and the hob.
▸ Ensure that the hob is in «connecting mode».
▸ Turn off the OptiLink function on the hob.
▸ Hold the
button on the range hood depressed for 15 seconds.
– During this time, the
and then go out again.
▸ Repeat the procedure for establishing a connection following the instructions given in
this section.
▸ If the error persists: Please contact Customer Services.
3.9
Remote control (accessories)
This appliance can be operated remotely (remote control is not included in the scope of
delivery, but is available for order as an accessory).
Decrease power level
Increase power level
Activate after-running time
Switch the illumination on/off
Do not place the remote control near any heat sources.
Dispose of the batteries at a suitable recycling point in accordance with national
regulations.
4
Care and maintenance
4.1
Cleaning the housing
Make sure no water gets inside the appliance. If water gets into the appliance, it
can cause damage.
Do not use abrasive cleaners, scouring pads, steel wool, etc. for cleaning, as they
can damage the surface. Disconnect the power supply before cleaning.
Exterior
▸ Clean using a clean, damp cloth and a mild detergent, then wipe dry.
Interior
Grease and condensate water can build up on the inside around the metal grease filters.
▸ Clean using a clean, damp cloth and a mild detergent, or a soft brush as needed,
then dry well using kitchen towel.
display symbol for after-running time should start to flash
4 Care and maintenance
15
Advertisement
Table of Contents
