Table of Contents
Advertisement
Submenu
Setting
Pattern Skip
Sets the pattern that is skipped when
changing the displaying pattern by
pressing the PIP/POP button on the
front panel while using 2 or 3 screens
display.
Set to "Not Skip" or "Skip" for the PIP1,
PIP2, POP1, or POP2 pattern.
PIP / POP
PIP Sub Screen
Sets the sub screen position for the 2 or
Position
3 screen displays (PIP).
Select from among "Lower Left, "
"Upper Left, " "Upper Right, " "Lower
Right. "
POP Sub Screen
Sets the sub screen position for the 2 or
Position
3 screen displays (POP).
Select from among "Left, " "Right. "
PORT A/PORT B
Sets the HD of 1920 × 1080 clipping size
HD Clipping Size
for each port when displaying 2 or 3
screen displays.
Custom Button
Assigns the function to the CUSTOM 1,
CUSTOM 2 or CUSTOM 3 button on
the front panel, and can set the
following functions to on or off.
Preset menu
The Preset menu is used to set the A to T and user 1 to
20 preset settings.
Submenu
Setting
Load Preset
Loads the settings that are stored in
Preset A to T.
Load User Setting
Loads the settings that are stored User1
to 20.
Save User Setting
Stores the current settings to User1 to
20.
User Name
Registers the user names to User1 to 20.
Load Default
Loads the default settings.
26
Troubleshooting
No Setting
Scan Size
Zoom
Flip
POP Sub Screen Position
Gamma
Mono
Phase
Chroma
Brightness
Contrast
Port C Display
Troubleshooting
This section may help you isolate the cause of a problem
and as a result, eliminate the need to contact technical
support.
The unit cannot be operated The key protection
function is enabled. Set the Control Lock setting to Off
in the Control Lock menu.
The black bars appear at the upper and lower
positions of the display When the signal aspect
ratio is different from that of the panel, the black bars
appear. This is not a failure of the unit.
Fan noise occurs. When the unit is used in a high
temperature environment, the fan operates to lower
the temperature. Noise will occur, but this is not due to
failure.
The DVI-D signal image is not displayed. When
inputting the signal protected with HDCP in the DVI-
D
connector and the HDCP setting is set to
"Disable, " the image is not displayed on the screen.
Set the HDCP setting to "Enable. "
The display is dark. When the unit is used in a
high temperature environment, the brightness of the
display backlight is reduced to lower the temperature
inside the unit. When this function is activated, the
power indicator flashes in amber.
Advertisement
Table of Contents
