Table of Contents
Advertisement
Submenu
Setting
Auto Input Select
Mode1:
Inputting signals to the input
connector automatically changes
connectors.
Mode2:
Gives priority to PORT A and
switches the PORT automatically.
Off:
The Auto Input Select function does
not operate. For details, see page
26.
Preset menu
The Preset menu is used to set the User1 to 20
preset setting.
Submenu
Setting
Load User Setting
Loads the settings that are stored
User1 to 20.
Save User Setting
Stores the current settings to User1 to
20.
User Name
Registers the user names to User1 to
20.
Load Default
Loads the default settings.
Troubleshooting
This section may help you isolate the cause of a
problem and as a result, eliminate the need to
contact technical support.
The unit cannot be operated The key
protection function is enabled. Set the Control
Lock setting to "Off" (page 26).
The black bars appear at the upper and
lower positions of the display When the
signal aspect ratio is different from that of the
panel, the black bars appear. This is not a
failure of the unit.
Images of the DVI-D signal and Display Port
2 signal are not displayed. When the
HDCP-protected signals are input to the DVI-D
input connector and DP2
connector, and the HDCP Setting is set to
"Disable," the image is not displayed on the
screen. Set the HDCP Setting to "Enable" (page
25).
While the logo is displayed, the operation
buttons do not operate when pushed.
While the logo is displayed, the operation
buttons do not operate. After the logo
disappears, the operation buttons can be
operated. The logo display time can be set in
the menu (page 27).
The display is dark. When the unit is used
in a high temperature environment, the
brightness of the display backlight is reduced
to lower the temperature inside the unit. When
this function is activated, the power indicator
flashes in green.
29
input
Advertisement
Table of Contents
