Table of Contents
Advertisement
Submenu
Setting
Sleep Mode
Sets the sleep mode to on or off. When
you set to "On, " the monitor enters into
power saving mode by turning off the
backlight if there is no input signal from
the selected connector for more than 1
minute.
Serial Remote
Serial Remote
Selects the using mode.
Ethernet Setting
Sets the Ethernet.
Custom Button
Assigns the function to the CUSTOM 1,
CUSTOM 2 or CUSTOM 3 button on
the front panel, and can set the
following functions to on or off.
Panel Display
Backlight
Adjusts the brightness of the display. A
higher setting increases the brightness
of the display, and a lower setting
darkens the display.
Monitor Information
Software Version
Displays the software version.
24
Adjustment Using the Menus
Off: Disables the serial remote
function.
RS-232C: Controls this unit via RS-
232C command.
Ethernet: Controls this unit via
Ethernet command.
IP Address: Sets the IP Address.
Subnet Mask: Sets the Subnet Mask.
Default Gateway: Sets "On" or "Off"
of the Default Gateway.
Address: Sets the Default Gateway.
Save: Saves the confirmed setting.
Cancel: Returns to the previous
setting from the confirmed setting.
No Setting
Scan Size
Flip
POP Sub Screen Position
APA
Gamma
Mono
Phase
Chroma
Brightness
Contrast
Initial Setup menu
The Initial Setup menu is used to set the default preset
value.
Submenu
Setting
Language
You can select the menu or message
language from the following languages.
English: English
Italiano: Italian
Español: Spanish
Deutsch: German
Français: French
Русский: Russian
Port A Input Select
Sets the input connector that is skipped
when changing the input signal by
pressing the PORT A button. Set to
"Not Skip" or "Skip" for the SDI, DVI-
D, HD15, VIDEO, S-VIDEO connector.
Port B Input Select
Sets the input connector that is skipped
when changing the input signal by
pressing the PORT B button. Set to "Not
Skip" or "Skip" for the SDI, DVI-D,
HD15, VIDEO, S-VIDEO connector.
Pattern Skip
Sets the pattern that is skipped when
changing the displaying pattern by
pressing the PIP/POP button on the
front panel while using multi-image
display. Set to "Not Skip" or "Skip" for
the PIP1, PIP2, POP1, or POP2 pattern.
PIP / POP
PIP Sub Screen
Sets the sub screen position for the
Position
multi-image display (PIP).
Set the position of the sub screen with
the "Lower Left, " "Upper Left, " "Upper
Right, " and "Lower Right" icons.
POP Sub Screen
Sets the sub screen position for the
Position
multi-image display (POP).
Set the position of the sub screen with
the "Right" and "Left" icons.
PORT A HD
Sets the HD clipping size for each port
Clipping Size/
when displaying multi-image display.
PORT B HD
Select from among "Normal, " "4:3, "
Clipping Size
"5:4. "
: Chinese
: Japanese
Hide quick links:
Advertisement
Table of Contents
