Set-Up & Assembly - H&S HI-DUMP 9215 Operator's Manual

Note: Determine right and left side of the
or parts lists call for hardened bolts, refer to Cap Screw Torque Value page to identify.
1. If you are assembling the HI-DUMP Box refer to the appropriate assembly instructions.
2. Make sure that all bolts are tightened.
3. Check wheel bolts upon delivery, and periodically thereafter. Wheel bolts should be tightened to 340
ft./lbs. of torque. This torque is needed for the axle to carry its' rated capacity.
4. Check the tires for proper air pressure. Manufacturers recommended pressure rating on the tire is
35 PSI maximum.
5. Lubricate the HI-DUMP completely. (See Lubrication Chapter in this manual).
6. Check all taillights that they are functioning properly.
7. For proper weight ballast, a tractor weight kit & weights, or solution in excess of 1,600 lbs has been
added to the tire opposite the dump side.
SET-UP & ASSEMBLY
HI-DUMP
by viewing it from the rear. If instructions