Table of Contents
Advertisement
UNLOADING/DUMPING THE WAGON
1. When dumping into a truck, or other receiving vehicle, choose a level area, free of obstructions.
2. With the operator in the tractor seat, and all others well clear of the HI-DUMP, actuate the "LIFT"
hydraulic control valve to raise the box to the desired dumping height.
3. When the desired dumping height has been reached, actuate the "TILT/DUMP" hydraulic control valve
to dump the box.
4. After the load is dumped, or the desired amount has been dumped, reverse the control valve to bring
the box back to the upright position.
5. Reverse the control valve for the lift cylinders to return the box to the transport position.
6. The entire dumping cycle should take approximately two minutes depending on hydraulic supply output.
7. Keep tires properly inflated and recheck wheel nuts periodically for tightness
CAUTION:
•
Never move the wagon when the box is raised. This will cause extreme stress on the structural
members, and may cause failure.
•
Never operate or dump the wagon with a low or flat tire. Always fill the tires on the non dumping
side (the side opposite the receiving vehicle) with chloride solu tion or an alternative ballast.
Failure to do so will cause instability when dumping the wagon and could cause the wagon to
overturn.
REAR TOW BAR
Rear Tow Bar allows you to hook on and pull out a box when stuck.
NOTE: The Rear Tow Bar is NOT designed to hook implements or anything that can be
towed to it.
OPERATION
Advertisement
Table of Contents
