Electrical System; Removing The Battery; Installing The Battery - KTM 250 SX-F 2017 Owner's Manual

14

ELECTRICAL SYSTEM

14.1

Removing the battery

Warning
Risk of injury Batteries contain harmful substances.
–
Keep batteries out of the reach of children.
–
Keep sparks and open flames away from the batteries.
–
Only charge batteries in well-ventilated rooms.
–
Maintain a minimum clearance from inflammable materials when charging batteries.
Minimum clearance
–
Do not charge deeply discharged batteries if charge is already below the minimum voltage.
Minimum voltage before the start of the charge
–
Dispose of batteries with less than the minimum voltage correctly.
14.2

Installing the battery

Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
Main work
–
Disconnect negative cable
–
Pull back positive terminal cover
battery.
–
Remove screw
–
Pull holding bracket
F00138-10
Main work
–
Insert the battery into the battery compartment with the terminals facing forward
and secure with holding bracket
(All SX‑F standard models)
Battery (C22S) (
(XC‑F US, SX‑F Factory Edition)
Battery (HJTZ5S-FP) (
–
Mount and tighten screw
Guideline
Remaining screws, chassis
–
Connect positive cable
Guideline
Screw, battery terminal
–
Connect negative cable
Guideline
H00386-10
Screw, battery terminal
Contact disks
the claws toward the battery terminal.
–
Slide positive terminal cover
Finishing work
–
Mount the seat. (
1 m (3 ft)
9 V
p. 50)
1
from the battery.
2
and disconnect the positive cable from the
3
.
4
forward and remove battery toward the top.
1
.
p. 106)
p. 106)
2
.
3
to the battery.
4
to the battery.
A
must be mounted under screws
7
over the positive terminal.
p. 50)
M6 10 Nm (7.4 lbf ft)
M5 2.5 Nm
(1.84 lbf ft)
M5 2.5 Nm
(1.84 lbf ft)
5
and cable sockets
81
6
with