KTM 250 SX-F 2017 Owner's Manual page 98

17 SERVICE WORK ON THE ENGINE
–
Remove screws
F00121-11
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
F00122-10
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Fill the oil filter with engine oil and position the oil filter in the housing.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
F00121-10
–
Remove filler plug
oil.
Engine oil
401955-12
Info
Too little engine oil or poor-quality engine oil results in premature wear of
the engine.
–
Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and death.
–
–
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the engine oil level. (
5
. Remove the oil filter cover with the O-ring.
6
out of the oil filter housing.
8
with the O-ring from the clutch cover and fill up with engine
1.0 l (1.1 qt.)
Always make sure there is sufficient ventilation when running the
engine.
Use an effective exhaust extraction system when starting or running the
engine in an enclosed space.
p. 94)
M6 10 Nm (7.4 lbf ft)
Engine oil (SAE 10W/50) (
Alternative engine Engine oil
oil for harsh oper- (SAE 10W/60)
ating conditions (00062010035)
and increased per- ( p. 112)
formance
96
7
.
p. 112)