Advertisement
6. MAINTENANCE AND STORAGE
Before working on the cutting system of the machine, switch off the
engine and remove the spark plug's cap.
a. Cleaning the mower
-
Cut grass is damp. Regular cleaning after each use will ensure better
functioning of the mower and reduce the risk of corrosion or seizure.
-
Having finished mowing, allow the engine to cool then remove
accumulated grass clippings from and around the engine with a brush.
-
Clean the grass collection bag annually with a brush or gentle spray of
water.
-
Disconnect the spark plug's cap and tilt the mower on its side with the air
filter and carburettor uppermost.
-
Remove any remaining cut grass from the cutting system with a scraper
and a brush.
-
Reposition the mower onto its four wheels.
-
Do not use a pressure washer or hot water to clean the mower. Be careful
to avoid soaking parts such as the engine, air cleaner, wheel bearings and
metal fastenings. Dry off the machine before storing by leaving it running
for a few minutes on a flat, clear surface to prevent corrosion or seizure.
b. Blade maintenance
WARNING: Wear gloves, turn off the engine and remove the spark
plug before proceeding.
The blade is made of hardened steel. To get a clean job, sharpen the
blade frequently, about every 25 hours of use. Make sure the blade is
always well balanced.
Insert a small iron pin (2 or 3 mm in diameter) into the hole in the middle
of the blade: it must remain horizontal. If the blade does not stay
horizontal, balance it by sharpening it further on the side where it is
leaning.
WARNING: Use only original spare parts. Poor quality replacement parts
can cause serious damage to your mower and affect your safety.
16
Advertisement
