Storing And Maintenance - Hyundai RASAERBA 4 TEMPI Manual

STORING AND MAINTENANCE

WARNING : Before performing any maintenance or cleaning work,
switch Off the engine and wait until
Cleaning
General cleaning
The lawn mower should be cleaned thoroughly every time after it has been used.
Always clean your lawnmower immediately after use.
Do not allow grass cuttings and other debris to become dry and hard on any of
the mower surfaces.
Dried grass remnants and dirt may impair the mowing
Check that the grass chute is free of any residual grass. Remove any such
residue.
Check the underside of the lawn mower and the blade mount. for this purpose ,tilt
the Lawn mower onto its left side (opposite the oil filler
NOTE: Before placing the lawn mower on its side , fully drain the fuel tank
using a petrol extraction pump. Do not tilt the lawn mower by more than 90
degrees.
Maintenance of the spark plug. As shown in Fig 22
1.Once the engine has cooled, pull off the spark plug
with a twist.
2.Remove the spark plug using a spark plug wrench
3.Clean the spark plug with a wire brush (not supplied ).
4.Using a feeler gauge set the gap to 0.75mm
5.Install the spark plug carefully by hand to avoid cross-
threading.
6.After the spark plug is seated tighten with the
spanner to compress the washer.
How to Service the Air Filter
As shown in Fig 23
Soiled air filters reduce the engine output by supply too little air to the carburetor.
if the air contains a lot of dust , the air filter should be checked more frequently .
WARNING！
Never run the engine without the air filter element
installed.
1. Remove the air cleaner outside cover (A). Be careful
to prevent dirt and debris from falling into the air
cleaner assembly.
2. Separate the Air Filter (A) from the Air Filter Housing (B).
3. Inspect the air filter. Clean dirty air filter with
water and mild soap. Allow air filter to dry thoroughly before
4. Install the air filter assembly onto the carburetor and secure with
14
the blade has come to a stop.
warm
ENGLISH
32
operation.
neck)
re-installation
screw.
Fig 22
Fig 23