Network Connection - ICP DAS USA BRK Series User Manual

2.2 Network Connection

There are three ways to log in to the BRK Web UI (User Interface) through BRK network connection. The
following is a brief description, and then the steps are described in subsections:
If the device has just arrived from the factory or is used for the first time (A), it is recommended to use
the connection method in Section 2.2.1 (same as the "Quick Start" included with the shipment).
If the device has been set up to connect but does not know the IP (B), it is recommended to use the
connection method in Section 2.2.2 (use Utility to search for the devices).
If the device has been set up and the connection IP (C) is known, you can directly enter the IP
connection in the browser website to log in.
The methods to login the BRK Web UI:
A. Using Factory Default Setting:
This way is suitable for those who is setting a new BRK or the PC network IP is not in the same
domain with BRK. This method changes the PC network IP to match the BRK factory default settings
to connect and login the Web UI. (Refer to
B. Using Software Utility:
Suitable for quick setting when multiple BRKs are connected in the same network but each IP
address is unknown. BRK products provide a free software utility to automatically search and
connect to BRKs on the internet and can Log into BRK Web UI.(Refer to
C. Using IP Address:
Suitable for the situation while BRK has a fixed IP and in the same domain network with the PC.
If the BRK has a fixed IP and in the same domain with the PC, users can directly enter the IP in the
address bar of a web browser and log in to the Web UI of the BRK.
BRK Series User Manual V1.0 - ICP DAS
Chapter 2.2.1)
10
Chapter 2.2.2)