Installation; Inserting The Cable - Bosch FPC-500 Installation Manual

12 en | Installation
–
3.2

Installation

Notice!
Install the fire panel in a location easily accessible to
emergency response teams (e.g. fire department).
Note permissible environmental conditions.
Install the fire panel at a height between 0,80 m and 1,80 m
above the ground that permits convenient operation by the user
and easy reading of the LCD display.
3.2.1

Inserting the Cable

Route the necessary cables for zones, inputs and outputs, as
well as the power supply, etc., and carefully punch out the cable
entries needed for this.
Warning!
Electrostatic discharge (ESD)! Electronic components could
!
become damaged. Ground yourself using a wrist strap or take
other suitable measures.
Remove the PC board if necessary. This is secured in the
housing with a grounding screw and snap-fit hook.
For cable entry on the upper side of the housing, use the pre-
formed round holes. For a stable and safe insertion, use cable
glands with M 20 x 1,5 screw joints (PG13,5)
The cable entries on the rear are intended for direct cable entry
of flush mounted cables.
2020.02 | 9.0 | F.01U.172.980
Two plastic foam blocks for securing the batteries
Conventional fire panel
Bosch Sicherheitssysteme GmbH