Segway SGW570F-A3 Manual page 98

OPERATION
more than one minute or close to the rated load. If the
winch motor feels very hot, stop winch and let it cool
for a few minutes.
◆ The rope end cannot bear the full load, and the rope
must rotate around the drum at least 5 laps.
◆ Avoid pulling the from extreme angles, as this will
cause the rope to be rolled on One end of the barrel
and damage the rope.
◆ Note that the rope-drawing capacity of the winch is the
maximum rope-drawing capacity of the first layer, only
the first the layer can only be pulled, do not operate the
winch with overload capacity.
◆ Never hook the rope back to itself, otherwise the rope
will be damaged. Use trunk protection protector.
◆ Before operation, make sure that the winch is firmly
installed on the vehicle or bracket.
◆ Before moving heavy objects, check the wire rope to
prevent kinks and uneven wire layers. The slack rope
must be properly tightened under a weight of about
100Kg.
◆ When pulling the load, be sure to lay a blanket or
protective layer on the wire rope near the hook end.
This will prevent the possibility of breaking the wire
rope and help prevent serious injuries and damage.
92