Dakota Digital BIM-22-3 Manual page 6

Locating sensors on a VHX system:
 From Step 19 of the previous page
1. Tap SW1 (I) once when the LCD displays TIRE LOCATE SKIP.
2. The display will switch to TIRE LOCATE BEGIN.
a. The second LCD will show the wheel location and possibly no pressure readings yet.
3. Make the tires are inflated to normal pressures (above low warning points).
4. Press and hold SW1 (I) to begin.
a. Tire pressures will show in LCD2.
5. If any corners show "- -" a message of FILL LOW TIRES will be displayed.
a. If the message FILL LOW TIRES is displayed, fill tires to above low warning point.
b. Driving the car a few minutes will speed up the process and not show 'Fill Low Tires'.
c. If no tire pressure(s) are being shown for a corner, deflate and inflate tires to display a pressure.
d. If one or more tire pressures do respond after several deflates and inflates over a couple of minutes,
and the display shows "- -", then stop and proceed to page 7.
6. Once tire pressures are being read and are at normal PSI, the message DEFLATE LF will appear.
a. Deflate that corner tire by only a few PSI, and wait a minute for the sensor to see the change.
b. If the car has been stationary for more than 15 minutes, it will take 60 seconds to see changes.
c. If the car was driven 5-10 minutes before starting LOCATE, the response time will be 5 seconds.
7. When a pressure drop is seen, DEFLATE RF will be displayed.
a. Deflate that corner tire by only a few PSI, and wait a minute for the sensor to see the change.
8. When a pressure drop is seen, DEFLATE LR will be displayed.
a. Deflate that corner tire by only a few PSI, and wait a minute for the sensor to see the change.
9. Once the LR sees a pressure drop FILL LOW TIRES will be displayed.
a. Fill the three tires back up to normal operating pressure.
b. The RR rear will not need to be deflated.
10. Tap SW1 (I) to exit the Locate menu.
11. TIRE LOCATE DONE will be displayed.
12. Tap SW1 (I) to go back to BIM pressure menu.
13. Tap SW1 (I) to display BIM SETUP DONE.
14. Press and hold SW1 (I) to exit BIM setup.
[6] MAN #650793