Display Screens / Sensor Location And Warning Levels - Dakota Digital BIM-22-3 Manual

Display Screens
Typical HDX/RTX Screens
Typical VFD3 Tire PSI Screens:
Setting Warning Levels and Sensor Locating
Low and high warning levels can be set individually for each tire/BIM channel.
Default low pressure warning is 25 PSI, and the default high pressure warning is 35 PSI.
The system will warn the driver when a tire's pressure has fallen below, or exceeded these levels.
On HDX and RTX systems, warnings are indicated to the user by red highlighted pressure values and an audible
alarm (if buzzer is installed and enabled).
On VFD3 and VHX systems, warnings are indicated by the pressure values blinking on and off.
Follow the procedure that corresponds to your dash system.
Locating Sensors

The sensors shipped with your BIM-22-3 are pre-programmed to the receiver and BIM-22-3 module.

Each sensor is color coded to be placed in a specific tire.

However, in the event a sensor is installed in an incorrect location, or when tires are rotated, the system can
be taught to "locate" the sensors without the need to move sensors to different tires.

Use the Locate procedure which corresponds to your display system below for relocating sensor position.

These procedures will only function properly if:
o
The original four TPMS sensors are mounted in tires on a vehicle.
o
The BIM-22-3 is picking up the sensors and all pressures are being displayed.
o
None of the sensors are replacements.
o
The BIM-22-3 is not a replacement or a serviced module.

Separate sensor locating procedures for each of the following control systems are available on the Dakota
Digital website for downloading and printing.

The Locate feature in the setup of the dash menu, will not function:
o
If one or more sensors are replacement sensors
o
If the BIM-22-3 module was replaced or serviced
o
If the dash system will not display one or more pressures, as it does not understand the new parts.
The BIM-22-3 will have to be stepped through the Special Operating Modes  to learn all the
o
sensors, on page XX.
Typical VHX Screens
Note: VFD3 systems can only display one tire pressure at a time
on the message center. Pressure readings are displayed similar to
other messages, and are preceded with LF, RF, LR, or RR.
LOCATION COLOR
Left Front Red
Right Front Green
Left Rear Blue
Right Rear Yellow
[3]
Typical VFD3X Screen
BIM CHANNEL
3-BIM-22-3
4-BIM-22-3
5-BIM-22-3
6-BIM-22-3
MAN #650793